TP-LINK EAP220 Guia do Utilizador descarregar pdf (Página 17)

Chapter 4 Network

On Network page you can configure the IP address of the standalone EAP.

Figure 4-1 Network Page

Dynamic/Static:

By default, the EAP device obtains an IP address from a DHCP server (typically a

router). Select Static to configure IP address manually.

Fallback IP:

If the EAP fails to get a dynamic IP address from a DHCP server within ten

seconds, the fallback IP will work as the IP address of the device. After that,

however, the device will keep trying to obtain an IP address from the DHCP

server until it succeeds.

DHCP Fallback

IP/IP MASK:

Enter the fallback IP/IP mask.

DHCP Fallback

Gateway:

Enter the fallback gateway.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 69 70

Sem comentários

TP-LINK EAP220 Guia do Utilizador Página 17