TP-LINK TL-SG2210P Guia do Utilizador descarregar pdf (Página 97)

no storm-control unicast

Command Mode

Interface Configuration Mode (interface gigabitEthernet / interface range

gigabitEthernet)

Example

Enable the unicast control function for port 5:

TL-SG2452(config)# interface gigabitEthernet 1/0/5

TL-SG2452(config-if)# storm-control unicast

storm-control rate

This command is supported only on TL-SG2452.

Description

The storm-control rate command is used to configure storm control rate. To

disable the storm control function, please use no storm-control rate command.

Storm Control function allows the switch to filter broadcast, multicast and UL

frame in the network. If the transmission rate of the three kind packets exceeds

the set bandwidth, the packets will be automatically discarded to avoid network

broadcast storm.

Syntax

storm-control rate rate

no storm-control rate

Parameter

rate —— The maximum ingress rate of the storm control packets. The packet

traffic exceeding the bandwidth will be discarded. The value of it can be 128k |

256k| 512k|1m | 2m | 4m | 5m | 10m | 20m | 40m | 50m in bps.

Command Mode

Interface gigabitEthernet / Interface range gigabitEthernet

Example

Specify the storm control rate as 2Mbps for port5:

TL-SG2452(config)# interface gigabitEthernet 1/0/5

TL-SG2452(Config-if)# storm-control rate 2m

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 198 199

Sem comentários

TP-LINK TL-SG2210P Guia do Utilizador Página 97